BN Glass Release Spray
Boron Nitride Glass Release Spray has been formulated specifically for the Art Glass Industry. It provides a water-based BN paint as an alternative to our flammable solvent-based aerosol BN Aerosol Lubricoat (sometimes referred to as just “ZYP” or “ZYP Mold Release Spray”). This water-based paint will take longer to dry than solvent-based paint. Glass Release is a non-hazardous product, thus allowing much lower shipping/handling costs. Just like our aerosol, this new easy-to-use trigger sprayer allows application of BN paint onto most any non-glazed (i.e., bisque) surface, substrate or mold. This product is not recommended for metal molds, but it can be made to work if the metal mold is preheated to ~150-200 C (~300-400 F) prior to application. Now shipping with mixing ball to help re-suspend the spray.
Link to the PDF for Special Instructions on how to avoid clogging of sprayer: BN Glass Release Spray Instructions
Link to PDF for Glass Release Helpful Information
Link to Datasheet: Glass Release Spray
How to Spray Molds:
- Shake vigorously until marble is heard and there is no sediment.
- Uncap and save the cap. Always start with a clean sprayer/tube and screw it onto bottle.
- Test sprayer on cardboard. Spray lightly (using side to side motion) on mold and allow time to soak in and dry.
- Once coating is dry to touch, re-apply a second coat if desired or if bare spots.
- Wet coating can be smoothed with small brush.
- Allow time to dry before using. Can be dried room temp or with a dryer.
- After use, remove sprayer and flush with water. Recap bottle with original cap.
- Link to the PDF for Special Instructions: BN Glass Release Spray Special Instructions
- Link to the PDF for Helpful information: Glass Release Helpful Information
- Link to the PDF Datasheet: BN Glass Release Spray
- All Glass Slumping and Forming using Bisque Molds
- Not Recommended for Metal Molds
- BN Glass Release Spray
- two 12 oz. bottles
- $43.00
- BN Glass Release Spray
- one 12 oz. bottle
- $26.00